background image

Assembly

Your sprayer has been mostly assembled at the factory. 

The only requirement will be for you to hook up your battery 

leads to a fully charged 12 Volt battery. The red wire must 

be connected to the "hot" lead, and the black wire should 

be connected to the ground.

NOTE: It is VERY important for you to test your sprayer 

with plain water before actual spraying is attempted. 

This will enable you to check your sprayer for leaks, 

without the possibility of losing any expensive 

chemicals.

Warranty/Parts/Service

Products are warranted for one year from date of purchase 

against manufacturer or workmanship defects.

Commercial users have a 90 day warranty.

Your authorized dealer is the best source of replacement parts 

and service. To obtain prompt, efficient service, always 

remember to give the following information...

 - Correct Part Description and/or part number.

 - Model number/Serial number of your sprayer.

Part descriptions and part numbers can be obtained from the 

illustrated parts list section(s) of this manual.

Whenever you need parts or repair service, contact your 

distributor/dealer first. For warranty work, always take your 

original sales slip, or other evidence of purchase date, to your 

distributor/dealer.

25 Gal. Corrosion-Resistant Polyethylene Tank

12 Volt Diaphragm Pump, 1.0 g.p.m.

15 Ft. Handgun Hose

18 Ft. max. vertical throw, 30 Ft. max. horizontal throw

Technical Specifications

Form No. 1332    [5004825    (12/09)]     Printed in the U.S.A.



(25 Gallon Lawn & Garden Spot Sprayer)

Owner's Manual

Your sprayer is equipped with (2) ON/OFF switches. One is 

on the wire assembly that you hook up to your battery, the 

other is on the pump itself, on the opposite end of the 

pressure switch. The "-" is the "ON" position and the "o" is 

the "OFF" position for the switches. Make sure both 

switches are depressed in the "-" position for operation.

In addition to the ON/OFF switch, the pump is equipped with 

an electronic pressure switch that is factory pre-set for it to 

shut off at 35 p.s.i.. This switch assembly is the 'square box' 

on the head portion of the pump.

Always fill the tank with a desired amount of water first, and 

then add the chemical slowly, mixing as you pour the 

chemical into the tank.  You may use the handgun to spray 

into the solution in order to mix the chemical and water.

Initially begin spraying by opening the handgun. This will 

enable the air in the line to be purged through the handgun 

tip, while building pressure.

The pumping system draws solution from the tank, through 

the strainer/filter, and to the pump. The pump forces the 

solution under pressure to the handgun and/or boom 

nozzles.

Open the handgun by squeezing the handle lever.

Rotating the adjustable nozzle tip on the handgun will 

change the tip pattern from a straight stream to a cone 

pattern (finer mist).

Operation

General Information

Thank you for purchasing this FIMCO product. The purpose of 

this manual is to assist you in operating and maintaining your 

lawn & garden spot sprayer. Please read it carefully, as it 

furnishes information which will help you achieve years of 

trouble-free operation.

1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049

Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440

www.fimcoindustries.com

Reviews: