Door Lock Installation
Step 1 Adjust Latch Backset
Adjust the Backset to match your door:
A) To Adjust to 2
‐
3/4” Backset pull square latch cam out.
B) To Adjust to 2
‐
3/8” Backset push square latch cam in
Step 2 Install Latch into the door
Install Latch into door positioned so that wedged shaped side of Bolt engages
the strike first when closing the door
Step 3 Install Lock body
Step 4 Wave Lever Only Left Handing Adjustment
A) Install exterior of lock by Inserting Lock Spindle Through Square Latch Cam and
Studs through round holes until lock is Flush with the door.
B) For Knobs with vertical key slots the knob should be installed with the Key Slot
positioned so that the Key will be teeth up when used.
C) Install the interior of the lock by inserting it over the spindle.Insert screws through
holes and tighten down with a hand
‐
held screwdriver.
Note: Check alignment of the lock as you tighten the screws to keep lock centered over
the bore Hole
A
B
C
A
B
Only Shaped Levers need to be adjusted for handing, straight Levers can be simply
installed flipped to the proper handing.. Wave Levers are shipped Right
‐
Handed.
A) Handles are removed by rotating the lever 45 Degrees and pushing the release
catch while pulling the lock off the spindle.
B) Once both sides are off they can be swapped so that the handles point onto the
door.
C) Secure the levers by pushing until they snap into place. Test by pulling out on the
lever
Note: Levers can only be removed when the lock is unlocked
Step 5 Install Strike
Entry Lock only –
Ensure Security Pin
Seats Properly
Right
Wrong
2-3/4”(70mm)
2-3/8”(60mm)
X
