QUICK GUIDE
EE211 - Humidity and Temperature Sensor for Continuous High Humidity
(Full User Guide at www.epluse.com/EE211)
Assembly and Installation
•
Insert the M20 cable gland included in the scope of supply into the corresponding opening of the EE211 basis unit and fix it tight
with the nut.
•
Install the EE07-MT temperature probe either directly onto the M12 connector of the EE211 basis unit or using the optional
probe cable.
Connection Diagram
EE211-M1J3 - Digital Output
EE211-M1A2/3/5/6 - Analogue Output
Address switches
Modbus RTU
15...35 V DC
24 V AC ± 20%
OUT1
OUT2
V
mA
V
mA
15...35 V DC
24 V AC ± 20%
Output: 0...5 V
0...10 V
0...20 mA
4...20 mA
Output:
Bus termination resistor 120 Ω (jumper)
Selection output signal U / I
Setup interface
Analogue Settings
Selection Output Signal Voltage / Current
The factory setup of the output signal and scaling corresponds to the type number as ordered.
The output signal voltage (U) or current 3-wire (I) can be selected with the DIP switch on the main electronics board (see
Connection Diagram - EE211-M1A2/3/5/6). This does not impact on the scaling of the outputs, which can be changed using the
EE-PCS Product Configuration Software and the optional USB configuration adapter HA011066.
Digital Settings - RS485 Interface with Modbus RTU Protocol
Hardware Bus Termination
If required, the bus termination shall be realized with 120 Ohm resistor, jumper on the board.
Jumper mounted
= bus terminated
Jumper not mounted = bus not terminated
Address Switch:
Address setting via EE-PCS Product Configuration Software
All DIP switches at position 0 → address has to be set via
Product Configuration Software
Factory setting: 239 (permitted values: 1…247).
Example: Slave address is set via configuration software.
Address setting via DIP switch
Setting the DIP switches to any other address than 0,
overrules the slave address set via configuration software
(permitted values: 1…247).
Example: Slave address set to 11 (= 0000 1011 binary).
0 0 0 0 0 0 0 0
0
1
1 1 0 1 0 0 0 0
0
1
Address Switch:
For details how to set the ID address, baud rate, parity and stop bits, please see
Full User Guide at www.epluse.com/EE211
.
Digital Settings
Factory settings
Selectable values
Baud rate
9600
9600, 19200, 38400, 57600, 76800, 115200
Data bits
8
8
Parity
EVEN
None, odd, even
Stop bits
1
1 or 2
Slave address
239
1...247
