Wireless Keypad User’s Manual v1.0
1
Wireless Keypad Users' Manual
This keypad convenient for you to use for the touch screen and fashionable appearance .it can work with alarm system
to control the security alarm system by password or RFID card . And it can be connected to the electronic lock system
to control the opening or closing of the door by password or RFID card.
The pairing method of keypad with alarm system
：
：
：
：
①
Connect power to the keypad, and you will see Arm indicator light flash once every second. This is Stand
by(Disarm) status, To keep internal back up battery in charge,please turn on the battery switch to ON position.
②
To avoid interference, the wireless signal need to be encrypted before pairing with alarm system. Input the
operation password. Factory default operation password is “123456”. Press “Enter”, you will see “SET” light on
which means it is in the status of setting. Input the 40+XXXX(four numbers) + ENTER and the encryption is
finished after the keypad makes a beep
，
Press “CHIME” to exit.
③
Start to pairing the code with the alarm system (same as the paring with the wireless remote controller).
Adjust the alarm host to the pairing code status. Press “ P Arm/Disarm/ Home Arms/ SOS” on the keypad,
it will emit pairing signal to the host.
Add the RFID to the keypad:
In the status of disarm, input the password “ ENTER, you will see the “SET” light on, which means it is in the
status of setting. Input the “201”+ ENTER, then swipe the card on the keypad, the adding is finished after the keypad
makes a beep. If more RFID cards need to be added, just repeat the process again. It can add 40 RFID cards to the
maximum.
Delete the RFID cards:
In the status of disarm, input the password “ENTER, you will see the “SET” light on, which means it is in the
status of setting. Input the “211”+ENTER, it will cancel all the RFID card. The RFID cards can not be cancelled one by
one through the keypad. If you want to cancel only one RFID cards, you have to cancel all and then pairing the needed
RFID cards.
Set the time of opening the door:
In the status of disarm, input the password “ ENTER, you will see the “SET” on, which means it is in the
status of setting. Input “50” + XX (01-99 seconds can be set) +ENTER. If the time you set to open the door is 20
seconds, the electrical lock will open for 20 seconds and then will close automatically.
（
The factory default time is 5
seconds to open the door.
）
Set the mode of opening the door:
In the status of disarm, input the password “ENTER, you will see the “SET” light on which means it is in the
status of setting. Input the “51 +1/2 (two modes are optional)” +ENTER.
Choosing the model of opening the door.
Mode 1: Swipe the RFID card or input the password, and then the door will be opened.
Mode 2: Swipe the RFID card first and then input the password, the door will be opened
Change the password:
For safety, please change the password after the setting and installing.
In the status of disarm, input the password “ ENTER, and then you will see “SET” light on which means it is in
the status of setting. Input “30+new p ENTER+ new pa ENTER”. Press “CHINME” to quit. At most 6
digit numbers can be set as password. The password should be remembered because it is used to operate the alarm
system and open the electrical lock.
