Attaching your DeWalt deep cut band saw to the Vertikut stand
1.
Unplug the saw and remove the blade.
2.
Remove the cutting guide from your saw by removing the two flathead screws
that hold it on.
3.
Take the assembled stand and find the two counterbored holes in the table top.
The tabletop goes on to the saw in place of the cutting guide you just removed.
4.
Line up the holes on the tabletop with the nuts in the saw and thread in the
flatheads on at a time.
5.
Re-install the blade making sure to slide it into the slot in the tabletop as you put it
into position on the saw.
