background image

1

ElEctric FirEplacE HEatEr

Model: MM360-52GCN 

iMpOrtaNt:

NOtE: DO NOt rEtUrN UNit tO tHE StOrE 

BEFOrE cONtactiNG OUr cUStOMEr SErVicE 

DEpartMENt. DO NOt DiSpOSE OF yOUr 

cartONS UNtil yOU arE cOMplEtEly SatiSFiED 

witH yOUr NEw FirEplacE HEatEr.

plEaSE NOtE: wHEN yOU OpEN tHE cartON carEFUlly cHEck 

tHE UNit aND MakE SUrE tHErE iS NO DaMaGE. iF yOU HaVE 

aNy prOBlEMS witH aSSEMBliNG tHE UNit, witH HOw tHE 

VariOUS FUNctiONS wOrk Or witH DaMaGE Or MiSSiNG partS, 

plEaSE GO tO OUr wEBSitE www.qUalitycraFt.cOM aND 

click ON cUStOMEr SUppOrt. 

NOtE: the electric fireplace heater may emit a slight harmless odor when first turned on.  

this is caused by activating the internal heater components for the first time and should not 

occur again.

INSTRUCTION MANUAL

attENtiON: 

1.  Find a location for the fireplace heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.

IMPORTANT SAFETY 

INSTRUCTIONS

wHEN USiNG ElEctrical appliaNcES, BaSic prEcaUtiONS SHOUlD alwayS BE 

FOllOwED tO rEDUcE tHE riSk OF FirE, ElEctric SHOck, aND iNJUry tO pErSONS, 

iNclUDiNG tHE FOllOwiNG:
1)   read all instructions before using this electric fireplace heater.
2)   this electric fireplace heater is hot when in use. to avoid burns, do not let bare skin touch 

hot surfaces. the grill directly in front of the heater outlet becomes hot during heater 
operation. keep combustible materials, such as furniture, pillows, bedding, papers, 
clothes, and curtains at least 3 ft (0.9 m) away from the front of the unit and keep them 
away from the sides and rear. 

3)   Extreme caution is necessary when any heater is used by or near children or individuals 

with disabilities and whenever the fireplace is left operating and unattended. 

4)   always unplug fireplace when not in use.
5)   Do not operate any electric fireplace with a damaged cord or plug or after the heater 

malfunctions, has been dropped or damaged in any manner. 

6)   Do not use outdoors. 

7)   this electric fireplace heater is not intended for use in bathrooms, laundry areas and 

similar indoor locations. Never locate heater where it may fall into a bathtub or other 
water container. 

8)   Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar 

coverings. arrange cord away from traffic area and where it will not be tripped over. 

9)   to disconnect fireplace, turn controls to off, then remove plug from outlet. 
10)  connect to properly grounded outlets only.
11)   Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this 

may cause an electric shock or fire, or damage the heater. 

12)  to prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on 

soft surfaces, like a bed, where openings may become blocked. 

13)  a heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, 

paint, or flammable liquids are used or stored. 

14)  Use this fireplace heater only as described in this manual. any other use not 

recommended by the manufacturer may cause fire, electric shock, or injury to persons. 

15)  avoid the use of an extension cord because the extension cord may overheat and cause 

a risk of fire. However, if you have to use an extension cord, the cord shall be No.14 awG 
minimum size and rated not less than 1875 watts.

16)  caution: Do not plug this product into a receptacle controlled by a wall switch or dimmer.
17)  when storing or transporting the unit and cord, keep in a dry place, free from excessive 

vibration and store so as to avoid damage.

SAVE THESE INSTRUCTIONS  

FOR FUTURE USE.

caUtiON:
iF yOU USE tHiS HEatEr iN cONJUNctiON witH a tHErMal cONtrOl, a prOGraM 

cONtrOllEr, a tiMEr Or aNy OtHEr DEVicE tHat SwitcHES tHE HEatEr ON 

aUtOMatically, rEMEMBEr tO OBSErVE all SaFEty warNiNGS at all tiMES. tHE 

FirEplacE HEatEr HaS SaFEty OVErHEat prOtEctiON. iF tHE OVErHEat prOtEctiON 

tripS, SwitcH OFF all SwitcH BUttONS aND wait apprOxiMatEly 5-10 MiNUtES. it 

SHOUlD rESEt aUtOMatically ONcE tHE UNit cOOlS DOwN.

warNiNG - DO NOt lOaD MOrE tHaN 22.7 kG (50 lBS) ON tHE tOp SHElF.

warNiNG: prOcEDUrES aND tEcHNiqUES iF NOt carEFUlly FOllOwED will rESUlt iN 

DaMaGE tO tHE EqUipMENt aND will ExpOSE tHE USEr tO tHE riSk OF SEriOUS iNJUry, 

illNESS Or DEatH. 

A 15 AMP circuit is required to operate this heater. If the breaker trips when the heater 
is used, then you may need to move the heater to another location or unplug other 
appliances that are on the same circuit. If you require an extension cord use one that is 
rated at 1875 watts. 

Summary of Contents for MM360-52GCN






















Reviews: