Installation and Operating
Instructions for
Davey Steriflo
®
UV, Ultra Violet
Water Treatment Systems
Models : UV50, UV70
Please pass these instructions onto the operator of this equipment.
DO NOT DISASSEMBLE ANY COMPONENTS UNTIL YOU HAVE FULLY READ
THESE INSTRUCTIONS!
Ultra violet radiation is harmful to skin & eyes.
DO NOT LOOK AT UV LAMP WHILE LAMP IS OPERATING.
WARNING: The UV Chamber operates under pressure. Under no
circumstances should the UV Chamber be disassembled unless the internal
pressure of the unit has been relieved. Failure to observe this warning will
expose persons to the possibility of personal injury and may result in
damage to the UV system or other property.
Maximum operating pressure for stainless steel UV chambers is 860kPa (125
psi). If this pressure can be exceeded or if operating close to this pressure
fit a suitable pressure limiting valve in the supply to the UV chamber.
If any electrical supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Minimum operating pressure is 0kPa. Installation on a flooded suction is
recommended. Installation under vacuum is not advised, any damage to
persons or associated equipment will not be covered under this guarantee.
