Installation Instructions
60”
15
-3/4'
2
"
dia
31
-1/2"
15
-3/4"
20
-1/2"
22
-1/4"
45
"
2
-1/4"
Tape
measure
Safety
glasses
Set
square
Pencil
Spirit
level
Silicone
sealant
Tools required
Weight - 205lbs
Weight with water - 656lbs
Installation notes
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
Store the bathtub in a safe place until you begin installation to avoid
any damage.
Assemble the bathtub on a mat to protect against damage to the bath
tub surface.
Avoid getting cement, grit, sand or masonry products on to the surface.
Protect and cover the bathtub during the installation period to prevent
damage from occurring.
Never use brown tape or gaffer tape directly on to the surface. If the
bath has to be repacked remember to avoid taping directly on to the
surface of the bathtub.
IMPORTANT
:
T
urn off the main water supply before connecting to
any existing pipework or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise
,
before drilling holes in a wall or floor.
Dimensions
Introduction
This bathtub has been fully inspected throughout the production
process and only leaves our factory after a 15
-
s
tep
QC process.
Don’t remove the old fixture before you unpack and inspect the new
bathtub.
Carefully remove the bat
h
tub from the box, taking care the bathtub is
carried in the bag and check that all parts have been supplied.
Before
beginning installation of the bathtub please check for any damage
that may have occurred during transport.
Note: Damage claims
cannot be made during or after installation.
Improper installation shall result in loss of warranty in case of damage
caused by impacts or rubbing against rough surfaces.
Prior to installing the bathtub prepare a connection of water inlet/outlet.
Pay attention to leveling of floor where the bath
t
ub will be located,
ensuring it can take the weight of the bathtub
,
water
and bather(s)
.
The customer may choose the type and location of the faucets,
installation instructions should be supplied by the faucet manufacturer.
The installation procedure of the bathtub may differ from that
described in the installation instructions, depending on where you
wish the bathtub to be located.
Wet surface of the bathtub may create a risk of slipping which may
increase by using soap, shampoo, oils and similar products.
IMPORTANT: Please read these instructions carefully before you
begin and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
RECOMMENDATIONS:
-
W
alls and floor
should be
fully tiled and finished before installation
.
T
his ensures that the product is installed flat to the tile face and allows
the
product to be easily removed if required in the future.
-
R
emove the protective packaging after installation of the bathtub.
-
O
nly fill the bathtub with water up to 2/3 of its height.
-
U
se
US-CW12
and
ITD5135
waste flow products with this bathtub.
Vicenza Petite
Bathtub
US-N6DCS
2/3 Height = 54 Gal./205L
