CARTON INVENTORY
®
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
WIRELESS GATEBELL KEYPAD
MODEL 920GA
TABLETOP MOUNTING
TO
PRESS
R ING
LEARN
LEARN
LEARN
Keypad
Remote Control
Power Adapter
Screws (4)
Receiver
1
TO
PRESS
R ING
LEARN
LEARN
LEARN
Insert remote control and power
adapter into receiver. Plug into outlet.
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
PRESS
RIN
G
TO
PRESS
RING
TO
LEARN
LEARN
3
2
1
4
5
Top Mounting Hole
TO
PRESS
R ING
LEARN
LEARN
LEARN
Bottom
Mounting
Hole
Battery Cover
Battery
Remove battery cover and battery.
Determine location for keypad. Mark
the bottom mounting hole.
Program remote control to the gate
operator radio receiver. Refer to your
gate operator manual for programming
instructions.
Remove foam spacer on underside of
keypad cover.
Check range before installing.
Using two people, hold the keypad and
receiver in the desired locations. Make sure
the keypad rings the gatebell when pressed.
If no chime is heard, repeat test using a new
location for the receiver.
NOTE:
For optimal range performance, mount the receiver to an external wall that is close to the gate operator.
DO NOT MOUNT TO METAL.
For the top mounting screw, mark 4
1/4" (10.8 cm) up the centerline from
the bottom of the keypad. Drill 1/8"
pilot holes for top and bottom screws.
See keypad mounting reference.
Secure keypad with bottom screw, using
care to avoid cracking plastic housing.
Reinstall battery and slide battery cover
up and snap it into place. Close cover.
Install top mounting screw, allowing
1/8" (3.2 mm) to protrude above surface.
Position keypad on screw head and adjust
for snug fit.
KEYPAD MOUNTING
(For reference only)
4 1/4"
(10.8 cm)
Drywall Anchors (2)
INSTALLATION • MOUNT KEYPAD
Lift
INSTALLATION • MOUNT RECEIVER
6
