BV-WF-01-LV WALL FAN
Installation Guide
WARNING
Please read these instructions carefully before installing, operating, or servicing the fan. Retain this guide for future reference.
1
SERVICE PARTS
1
2
4
5
6
12
3
3
3
8
9
7
11
10
13
14
15
1. Grille
2. Sheet Metal Nut
3. Sheet Metal Screws
4. Motor Mounting Bracket
5. Motor
6. Blade
7. Wiring Box Cover
8. Green Ground Screw
9. Wiring Box
10. Housing
11. Receptacle
12. Spring
13. Adjustable Duct
14. Wall Cap
15. Aluminum Ring
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
1. Use this unit only in the manner intended
by the manufacturer. If you have questions,
contact the manufacturer at the address or
telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be
locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be
done by a qualified person(s) in accordance
with all applicable codes and standards,
including fire-rated construction codes and
standards.
4.
Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to
prevent backdrafting. Follow the heating
equipment manufacturer’s guideline and
safety standards such as those published
by the National Fire Protection Association
(NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
5. When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.
6. Ducted fans must always be vented to the
outdoors.
7. This unit must be grounded.
8.
To reduce risk of fire, use only metal ductwork.
9. The electric service supply voltage must be
120V 60HZ.
1. For general ventilating use only. Do not use
to exhaust hazardous or explosive materials
and vapors.
2. To avoid motor bearing damage and noisy
and/or unbalanced impellers, keep drywall
spray, construction dust, etc. off power unit.
3.
Please read specification label on product for
further information and requirements.
4. Do not use in the bathroom.
5. To reduce the risk of injury, install fan at least
2.1m (7 feet) above the floor.
CAUTION
USE AND CARE
WARNING
: Switch off power at service panel and
lock service panel before cleaning or servicing
this fan.
TO CLEAN FAN ASSEMBLY:
Unplug motor from receptacle. Remove the motor
assembly by loosening the mounting screws and
rotating the motor assembly.
Gently vacuum motor assembly and inside of
housing.
METAL AND ELECTRICAL PARTS SHOULD
NEVER BE IMMERSED IN WATER.
PERIODCALLY CHECK THE OUTER LOUVER
FOR ACCUMULATED DUST, LINT, ETC.,
WHICH MAY INTERFERE WITH PROPER
LOUVER CLOSURE.
WARNING
: DO NOT SPRAY WATER INTO
LOUVER—DAMAGE TO THE FAN COULD
OCCUR AND WATER COULD ENTER HOUSE.
There is no need to oil the motor on this fan.
WIRING DIAGRAM
AUTOMATIC TERMINAL SWITCH
FAN HOUSING
JUNCTION BOX
TO 120V/60HZ
BLACK WIRE
WHITE WIRE
GREEN WIRE
