7700 Old Georgetown Road, Suite 300 | Bethesda, MD 20814
301.664.5242 | Toll Free 866.692.7486 | www.brivo.com
Brivo Reader Installation
Wall Mounted Reader Installation
This installation guide applies to the following types of readers:
•
B-SS
–
Smart Single Gang Reader
•
B-BSS
–
Bluetooth, Smart Single Gang Reader
•
B-BSPS
–
Bluetooth, Smart, Prox Single Gang Reader
•
B-SK
–
Smart Single Gang w/Keypad
•
B-BSK
–
Bluetooth, Smart Single Gang w/Keypad
•
B-BSPK
–
Bluetooth, Smart, Prox Single Gang w/Keypad
The Following tools will be needed to install
a wall mount reader:
•
Phillips Screwdriver
•
1” (25mm), 1/8” drill bits
•
T8 Security Torx Bit (optional for increased tamper
detection)
Included:
•
Reader, Backplate, and Wall Plate
•
(2) #6 screws
•
(1) #4-40, (1) pin-in-torx
•
(4) #4 screws
Wire the Cable to the Control Panel
1
Install Metal Wall Plate to Single Gang Box
Connect the wall plate to the single gang box using the provided #6 screws. Alternatively, you can use the provided #4 screws in
the four outer holes for other installation requirements. Drywall installations will require molly bolts.
Alternative for
situations outside
of a single gang box
installation
Standard Single
Gang Box
Installation
2
Attach the Reader to the
Wall plate
Align the reader so that the tabs of the base plate
slide into the slots on the wall plate and slide the
reader into position.
3
IMPORTANT:
For Bluetooth readers, write down the serial
number of the Brivo reader to configure it for Brivo Onair Pass.
Serial
Number
