background image

GENERAL SAFETY RULES - FOR ALL BATTERY OPERATED TOOLS

WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS

. Failure to follow all

instructions listed below, may result in electric shock, fire and/or serious personal injury

SAVE THESE INSTRUCTIONS

WORK AREA

Keep your work area clean and well lit.

Cluttered benches and dark areas invite

accidents.

• Do not operate power tools in explosive atmospheres, such as in the presence of

flammable liquids, gases, or dust. 

Power tools create sparks which may ignite the dust or

fumes.

• Keep bystanders, children, and visitors away while operating a power tool.

Distractions can cause you to lose control.

ELECTRICAL SAFETY
• Do not abuse the cord. Never use the cord to carry the tool. Keep cord away from

heat, oil, sharp edges or moving parts. Replace damaged cords immediately.

Damaged cords may create a fire.

• A battery operated tool with integral batteries or a separate battery pack must be

recharged only with the specified charger for the battery. 

A charger that may be suitable

for one type of battery may create a risk of fire when used with another battery.

• Use battery operated tool only with specifically designated battery pack. 

Use of any

other batteries may create a risk of fire.

PERSONAL SAFETY
• Stay alert, watch what you are doing and use common sense when operating a power

tool. Do not use tool while tired or under the influence of drugs, alcohol, or
medication.

A moment of inattention while operating power tools may result in serious

personal injury,

• Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your

hair, clothing , and gloves away from moving parts.

Loose clothes, jewelry, or long hair

can be caught in moving parts. Air vents cover moving parts and should be avoided.

• Avoid accidental starting. Be sure switch is in the locked or off position before

inserting battery pack.

Carrying tools with your finger on the switch or inserting the battery

pack into a tool with the  switch on invites accidents.

• Remove adjusting keys or wrenches before turning the tool on.

A wrench or a key that

is left attached to a rotating part of the tool may result in personal injury.

• Do not overreach. Keep proper footing and balance at all times. 

Proper footing and

balance enable better control of the tool in unexpected situations.

• Use safety equipment. Always wear eye protection.

Dust mask, non-skid safety shoes,

hard hat, or hearing protection must be used for appropriate conditions.

TOOL USE AND CARE
• Use clamps or other practical way to secure and support the workpiece to a stable

platform.

Holding the work by hand or against your body is unstable and may lead to loss of

control.

• Do not force tool. Use the correct tool for your application.

The correct tool will do the

job better and safer at the rate for which it is designed.

• Do not use tool if switch does not turn it on or off.

A tool that cannot be controlled with

the switch is dangerous and must be repaired.

• Disconnect battery pack from  tool or place the switch in the locked or off position

before making any adjustments, changing accessories, or storing the tool.

Such

preventative safety measures reduce the risk of starting the tool accidentally.

• Store idle tools out of reach of children and other untrained persons. 

Tools are

dangerous in the hands of untrained users.

• When battery pack is not in use, keep it away from other metal objects like: paper

clips, coins, keys, nails, screws or other small metal objects that can make a
connection from one terminal to another. 

Shorting the battery terminals together may

cause sparks, burns, or a fire.

• Maintain tools with care. Keep cutting tools sharp and clean. 

Properly maintained tools,

with sharp cutting edge are less likely to bind and are easier to control.

• Check for misalignment or binding of moving parts, breakage of parts, and any other

condition that may affect the tool’s operation. If damaged, have the tool serviced

VEA EL ESPAÑOL EN LA CONTRAPORTADA.

SAVE THIS MANUAL FOR FUTURE REFERENCE.

INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y
PÓLIZA DE GARANTÍA. 

ADVERTENCIA: 

LÉASE ESTE

INSTRUCTIVO ANTES DE USAR EL PRODUCTO. 

INSTRUCTION MANUAL

Catalog No. PS2400

2

2

2

2

4

4

4

4

  

  

V

V

V

V

o

o

o

o

ll

ll

tt

tt

  

  

C

C

C

C

o

o

o

o

rr

rr

d

d

d

d

ll

ll

e

e

e

e

s

s

s

s

s

s

s

s

  

  

D

D

D

D

rr

rr

ii

ii

ll

ll

ll

ll

Cat. No. PS2400 

Form # 90521527    (JUNE-07)     Copyright © 2007 Black & Decker      Printed in China

before using.

Many accidents are caused by poorly maintained tools.

• Use only accessories that are recommended by the manufacturer for your model.

Accessories that may be suitable for one tool may create a risk of injury when used on
another tool.

SERVICE
• Tool service must be performed only by qualified repair personnel. 

Service or

maintenance performed by unqualified personnel may result in a risk of injury.

• When servicing a tool, use only identical replacement parts. Follow instructions in

the Maintenance section of this manual.

Use of unauthorized parts or failure to follow

Maintenance Instructions may create a risk of shock or injury.

SPECIFIC SAFETY RULES

• Hold tool by insulated gripping surfaces when performing an operation where the

cutting tool may contact hidden wiring or its own cord.

Contact with a "live" wire will

also make exposed metal parts of the tool "live" and shock the operator.

• 

When working on a ladder or on scaffolding be sure to lay the tool down on its side
when not in use.

Some tools with large battery packs will stand upright but may be easily

knocked over.

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and

other construction activities contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:

• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and 
• arsenic and chromium from chemically-treated lumber (CCA).

Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals:  work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.

Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed areas
with soap and water. 

Allowing dust to get into your mouth, eyes, or lay on the skin may

promote absorption of harmful chemicals.

WARNING:

Use of this tool can generate and/or disperse dust, which may cause serious

and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away from face and body.

The label on your tool may include the following symbols.

V ..........................volts

A..........................amperes

Hz ........................hertz

W ........................watts

min ........................minutes

......................alternating current

......................direct current

no ........................no load speed

..........................Class II Construction

........................earthing terminal

........................safety alert symbol

.../min ..................revolutions or 

reciprocations 

per minute

SAFETY GUIDELINES - DEFINITIONS

It is important for you to read and understand this manual. 
The information it contains relates to protecting YOUR SAFETY and PREVENTING PROB-
LEMS. The symbols below are used to help you recognize this information. 

DANGER: 

Indicates an imminently hazardous situation which, if not avoided, will result

in death or serious injury.

WARNING: 

Indicates a potentially hazardous situation which, if not avoided, could

result in death or serious injury.

CAUTION: 

Indicates a potentially hazardous situation which, if not avoided, may result

in minor or moderate injury.

CAUTION: 

Used without the safety alert symbol indicates a potentially hazardous situation

which, if not avoided, may result in property damage.

3

4

1

2

Trigger Switch

Interrupteur à gâchette

Conmutador tipo gatillo

Depress for reverse (this side)

Enfoncer pour la marche

arrière (ce côté)

Presione para dirección

reversa o contraria a las

manillas del reloj (este lado)

Depress for forward (other side)

Enfoncer pour la marche avant

(autre côté)

Presione para dirección normal

o de las manillas del reloj (el

otro lado)

Torque Adjust Collar

Collier de réglage de couple

Rueda de ajuste del par torsor

BEFORE RETURNING THIS PRODUCT 

FOR ANY REASON PLEASE CALL 

1-800-544-6986

IF YOU SHOULD HAVE A QUESTION OR EXPERIENCE A

PROBLEM WITH YOUR BLACK & DECKER PRODUCT,

CALL 1-800-544-6986

BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No., TYPE No., AND

DATE CODE (e.g. 20000130M). IN MOST CASES, A

BLACK & DECKER 

REPRESENTATIVE CAN RESOLVE

YOUR PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A CALL.

YOUR FEEDBACK IS VITAL TO BLACK & DECKER.

5

6

K

K

K

K

E

E

E

E

Y

Y

Y

Y

II

II

N

N

N

N

F

F

F

F

O

O

O

O

R

R

R

R

M

M

M

M

A

A

A

A

T

T

T

T

II

II

O

O

O

O

N

N

N

N

Y

Y

Y

Y

O

O

O

O

U

U

U

U

S

S

S

S

H

H

H

H

O

O

O

O

U

U

U

U

L

L

L

L

D

D

D

D

K

K

K

K

N

N

N

N

O

O

O

O

W

W

W

W

::

::

• Charge battery for 9 hours before first use. For more information see

“CHARGING THE POWER PACK”.

Summary of Contents for 90521527







Reviews: