303021267258_10x14cm_34160_21N-OEM-B16_
亲子双人游泳圈说明书
OWNER’S MANUAL
43042081
inflatable adult and infant float with canopy
WARNING:
WILL NOT PROTECT AGAINST DROWNING USE ONLY UNDER
CONSTANT SUPERVISION
WARNING
1. No protection against drowning.
2. Fully inflate all air chambers.
3. Swim seat is not a life saving device and must be used only under constant, competent
supervision.
4. The supervisor should be within arm's reach of the wearer.
DO NOT USE:
1. By user beyond or below designated weight range / age.
2. Within child’s standing depth.
3. In breaking waves.
4. In bath tubs.
Inflate and Fit
1. Open the safety valve, squeeze the valve at the base and inflate the air chamber by
steps with an air pump (Pump is not included). Fill the chambers until most of the
wrinkles are gone and it feels firm to touch but NOT hard. Close the valve firmly when
finished. Press the valve downward into the air chamber, so that it does not get over the
surface.
Note:
Never over-inflate or use compressed air to inflate.
2. With the swim seat facing up, position the child’s legs through the bottom leg holes of
the swim seat. Child’s body should be approximately upright. Be sure the swim seat fits
around the child’s lower body securely, and the water level is at or about the level of the
NIPPLE. Place the swim seat at first into water, out of the child’s standing depth and
then put the child into the swim seat.
Warning:
Do not bite or chew the product as pieces that may be bitten off from the
material may cause a choking hazard.
3. The use of diapers or any other apparel or device shall not lead to an entrapment of the
child inside the seat.
Remove and Deflate
1. In sufficiently deep water take the baby off the swim seat first.
2. Pull out the safety valve, pinching the valve to release the air.
Maintenance and Storage
1. Rinse with water and air dry thoroughly before storing it. Place it in a dry place, normal
room condition, out of direct sun light and the deflated swim seat should not be
compressed by other weights on it.
2. Check seams and foil regularly for tears and holes. If there is any defect, please discard
the products and replace by a new one.
