BROOK DESIGN HARDWARE LTD
B
D
H
B
D
H
BROOK DESIGN
HARDWARE LTD
B
D
H
BROOK DESIGN
HARDWARE LTD
BDH
BROOK DESIGN
HARDWARE LTD
B
D
H
The
Standard PIR Timer (2 wire)
is part of the Elkay family of switches,
timers and detectors which save
energy and increase convenience in
and around your home, garden
or premises.
Rating at 240V ac 50Hz
•
Time Delay: 2 min - 1 hour
•
10A All lighting load types only - Including
lighting loads that are LED, Compact
Fluorescent, Incandescent and Resistive
•
This switch cannot be used on
contactors
Fitting and Operating Instructions
1.
Prior to fitting ensure mains power is
switched OFF and Live In and Switch Live
are identified. Also where applicable
remove metal back box lugs that are
not being used.
2. For installation purposes, set the dip
switches for
test mode as shown in
Timing Diagram and gently rotate the lux
pot anti-clockwise towards the plus (+).
3. Securely fit Live In and Live Out into the
terminals marked Lin and Lout.
4. Press Reset Button on each PIR in
the circuit.
5. Turn mains power ON. Wait for 1 minute
for PIR to initiate itself.
6. To test the PIR timer leave the area and
the load will switch OFF in approximately
60 seconds as long as no movement or
external sources are detected.
7. To test the timer re-enter the area and the
PIR Timer will detect movement and
trigger the load ON.
8. Reset the desired time delay with
reference to timing diagram and the lux
level pot to desired ambient light
level required.
9. Ensure the timer is secured to the back box
securely.
Note: Ensure no cables rest
on Reset button when switch is attached
to wall. Do not press the PIR dome for
any reason.
10. A capacitor (PFCC-1) will be required when
switching low wattage or some LED lighting.
–
STANDARD
PIR TIMER
376B-1
2 wire
Instruction Guide
