Controller EEL-S4
The Bansbach S4 series is a range of battery-based actuator controllers developed especially for mobile
applications. The controller can manage up to 4 actuators with a wired handset and it is supplied by
either a NiMH Li-Ion-battery.
The controller may be configured using PC software which may be ordered separately from Bansbach.
This allows patterns of operation, stroke length, speed, etc. for the connected actuators to be adjusted.
EEL-S4
Battery Based Actuator Control System
Preparation
Before the system may be used, the battery must be charged using the accom-
panying charger. It takes 5-8 hours to fully charge a battery.
The yellow LED lights up when the charger is connected to power. Place the
battery in the charger by sliding it in and rotating it until it is pulled into place by
the magnets. The green LED will flash at approx. 1 second intervals while the
battery is being charged. Once charging is complete the green LED remains
permanently lit. Remove the battery by rotating it 90 degrees. It will then be
ejected and be ready for use.
Once the battery is fully charged, insert it into the controller. Follow the same
procedure as for the charger. If everything is OK, the controller will simply sound a beep (one second)
once the battery is in place. If the system has any faults, the beep will be followed by an error indication
according to table 1 below.
When the battery requires recharging, transfer it to the charger as described above. It is recommended
that you keep an extra battery on hand to avoid disruption to operation.
Always wait at least two seconds after the last actuator has stopped moving before removing the battery.
Otherwise the controller may not have time to store the position and it may be necessary to perform
0-point calibration as described in section „Normal operation“.
Input voltage: 24VDC
Operating temperature: 5°C to 40°C
Relative humidity: 20% to 70%
Atmospheric pressure: 1atm
Max. operating attitude: 2000m
Battery technology: NiMH or Li-Ion
Technical data and model designation:
What is the EEL-S4?
MANUAL
