1TT –TIMER + TERMOREGOLATORE - Reference Manual - Pag. 1 di 7
www.bebmilano.it
1TT – USER MANUAL
TIMER + TEMPERATURE CONTROLLER
When the device is turned-on its display shows the following text:
-
SEL
upper display
-
CAL
lower display
After a few seconds the upper display shows the value of the measured temperature;
and the lower display the value of a time set.
Time setting:
•
Press the
S
button, so the upper display will show
timE
; the lower display the value of one time,
•
Use the following buttons
▲
to
set the requested time value.
In order to memorize it, reset ( 7 – 5) or press ON/OFF.
Temperature setting (After time setting)
•
Press the
S
button, so the upper display will show
°C
and the lower display a temperature value;
Use the
▲
buttons to set the required temperature value.
TO ACCES THE TEMPERATURE PARAMETERS USING THE PASSWORD.
•
Press for
5
seconds the
S
button,so the upper display will show
SET
and the lower
t1
.
Pres the
▲
button so the upper display will show
SET
, the lower
timE
.
•
Press again the
▲
button and the lower display will show
dEv
.
•
Press again the
▲
button and the lower display will show
PAS
.
•
Press the
S
button and the lower display
will show
100
; enter the password
123
.
•
With the
S
button every pulse corresponds to a parameter (see the Instructions Manual).
TO ACCESS THE TIMER PARAMETERS USING THE PASSWORD.
Press for 5 seconds the
S
button ; the upper display will show
SET
, the lower display .
t1
the upper right
red led will be switched on (
1)
Press the
▲
button and the
display will show
timE
,
Press the
S
button to access the following parameters:
toP
absolute max limit block
MobE
relay function
InP
pulse timed relay
Rit
delayed relay
dir
count
UP
or
dn
TS
Setting
of the times scale
0 = 99,99
1 = 999,9
2 = 9999 sec.
3 = 9999 min.
4 = 59 min. 59 sec.
Use the
▲
and
buttons to select
At the end of every change the display will show 9 9 confirming the successfully completed programming.
