USER GUIDE
OWNER’S MANUAL
THE GAS TORCH DOES NOT CONTAIN ANY BUTANE GAS WHEN
FIRST PURCHASED.
Read these instructions carefully and familiarise yourself with the
product before lighting or using. Re-read the instructions periodically
to refresh your memory. Retain these instructions for future use.
FILLING THE TORCH
LIGHTING THE TORCH
• Use only butane fuel.
• Fill only outdoors in a well ventilated area.
• Make sure the ON/OFF valve is in the OFF position. (Fig 4). Turn
clockwise until it stops.
• Remove base and turn the unit upside down and insert fill stem into
fill valve and press down for 3 to 4 seconds, repeat three times.
Back spray from fill valve indicates that appliance is full. (Fig 1)
• Do not add attachments to the end of the gas refill canister as the
valve is designed to accept the gas direct from the gas can without
any adaptors added (these adaptors are only usually provided for
cigarette lighters).
FLAME ADJUSTMENT
SHUT DOWN
• Adjust the torch flame to 1.5cm to 2.5cm for efficient fuel use.
• Cooler flames may be achieved by adjusting the air collar until the
flame softens. Do not do this while operating as the air control
collar gets hot.
WARNING
• Turn ON/OFF valve clockwise until it stops. Be sure flame is out and
torch is cool before storing torch.
TEMPERATURES WILL EXCEED 40°C.
• Turn the ON/OFF knob 2/3 turn counter clockwise. Gas will blow
out of the burner with a hiss. (Fig 2)
• Push the ignition button. The flame will ignite instantly. (Fig 3)
• If torch does not light, then press igniter button again. If torch still
does not light, check and make sure that the air control collar is not
covering the vent hole. Turn off the ON/OFF valve (turn ON/OFF
valve clockwise until it stops). Hold torch at an angle so that you
can see inside the front of the burner. With the fuel shut off, press
the ignition button, a spark should jump from the ignition pin to the
inner face of the burner. Do not press the ignition button with
burner pointed toward yourself or anything flammable. If spark
jumps, repeat lighting procedure. If torch still does not light, try
lighting after turning on 1/2 and 2/8 turn.
6. MAKE SURE THE ADJUSTMENT KNOB IS FIRMLY CLOSED
7.
AND THE FLAME IS COMPLETELY EXTINGUISHED AFTER
USING.
8.
1. DO NOT TOUCH FLAME GUARD OR AIR CONTROL COLLAR
WHILST IN USE OR SOON AFTER AS IT WILL BE HOT.
2. KEEP OUT OF REACH OF CHILDREN.
3. BUTANE GAS IS EXTREMELY FLAMMABLE, PLEASE HANDLE
WITH CARE.
4. ALWAYS POINT AWAY FROM EYES AND BODY WHEN
IGNITING OR OPERATING.
5. DO NOT STORE IN DIRECT SUNLIGHT OR ANY PLACE WHERE
DO NOT CONTINUALLY USE THIS TOOL FOR LONGER THAN
ONE HOUR.
AFTER USING, LET THE TOOL COOL DOWN BEFORE
STORAGE.
9. DO NOT PUNCTURE OR DISPOSE OF IN A FIRE.
10. READ AND FOLLOW ALL INSTRUCTIONS AND CAUTIONS ON
THE FUEL CANISTER.
COOK’S TORCH
WITH GAS
