Before you begin…
Please read these instructions carefully.
Following the steps in the right order will make the installation
much easier and help make sure the new lock is fitted properly.
Give yourself time…
Please ensure you give yourself plenty of time to install this
product correctly and adjust if required.
Please Note
If at any point you feel you can not successfully complete
the installation you can call our helpline on 01902 364606.
Tools required:
• Tape measure
• Pencil
• Cross-head screwdriver
• Flat blade screwdriver
• Drill and drill bits
• Hacksaw
• Mole Grips or Vice
Pack contents
Fixings included:
• Maximum Security replacement multi-point lock with
top and bottom hooks for professional use
Fitting Instructions for
Timber/Composite model
PAS3621: 2011 BS Replacement Door Lock
An ASSA ABLOY Group brand
4mm
2.5mm
1x
See screwpack
42x 8x
1x
50mm
Small
Cylinder
screw
Split spindle set for
nightlatch function
25mm
1x
1x
MAX
820mm
MIN
408mm
MIN
385mm
MAX
845mm
92mm
1x Lock
3x Keep
Hook unit
Hook faceplate
(16 or 20mm
wide)
Centre
con rod
Hook con rod
Hook keep
Centre keep
Large
Cylinder
screw
1x
1x
35mm
or
45mm
ALL DIMENSIONS IN MILLIMETERS
FIRST ANGLE PROJECTION
DO NOT SCALE
--WIP
03/12/2014
ISSUE
DESCRIPTION
DATE
NOTICE TO PERSONS RECEIVING THIS DRAWING AND / OR TECHNICAL INFORMATION.
Assa Abloy Limited, claims propriatory rights to the material disclosed hereon. This drawing and / or technical information is issued in confidence for engineering information
only and may not be reproduced or used to manufacture anything shown or referred to hereon without direct written permission from Assa Abloy Limited., to the user. This
drawing and / or technical information is the property of Assa Abloy Limited. and is loaned for mutual assistance to be returned when its purpose has been served.
THIS DRAWING AND / OR TECHNICAL INFORMATION IS THE PROPERTY OF ASSA ABLOY LIMITED.
CUSTOMER
Centre case-faceplate assy
TITLE
SCALE
CGW
DRG NUMBER
OF
ASSA ABLOY LIMITED
WILLENHALL, WEST MIDLANDS.
WV13 3PW. TEL. (01902) 366911
PRODUCT ENGINEERING DEPT.
A1
MATERIAL
1
--WIP
1
STATUS
DRAWING LIMITS UNLESS STATED
PROJECT NO.
13YDWS004-704
PRODUCT
DRAWN
DEVELOPMENT
DATE
SHEET
TREATMENT AND FINISH
ISSUE
Centre unit
Centre
faceplate
Cover plate
2mm
