User instructions
ArcSource Wall 3, ArcSource Twin Wall 3
The products generate colored light by means of high power LEDs.The products were designed for exterior
use and they are ideal for locations where signaling,directional or effect lighting is required.
1. Attention
Consider the respective national norms during the installation!
Do not install the unit near naked flames.
Avoid using the unit in locations subject to possible impacts.
Do not attempt to dismantle or modify the unit.
Do not install the module in badly ventilated location
Avoid looking directly into the LED light beam at close range.
2. Installation
This fixture
can be arranged in any position orientation. Body of stainless steel tube is mounted on 75mm
diameter mounting base.
The ArcSource Wall unit should be connected to the ArcPower driver (see ArcPower 36/72/44/360/ 6x6/6x2
user manual for full details of mains power requirements and DMX operation).
Use a cable splitter if more than one LED module has to be connected to the one LED output of the driver,
the connection between the ArcPower driver and the splitter is a standard RJ45 patch cable category 5 wired
:.
3. Connection
ArcSource Wall 3 / Twin Wall 3
