IN
STA
L
L
G
U I D E
I
RE617 Heat Alarm
is a fire-protection
device that alarms when it detects
temperatures above 135°F (57°C) or
temperature changes greater than 15°F
(8.3°C)/min and the temperature is
above 104ºF (40ºC).
Features
• UL539 and ULC-S530 listings
• Heat detection
Quick Start Guide
1. Remove the mounting plate.
2. Pull the battery tab.
3. Restore the mounting plate and
twist it fully onto the Heat Alarm.
Note: Enrollment is possible
only
if the mounting plate is twisted
onto the Heat Alarm.
4. Enroll the Heat Alarm by placing the
panel into wireless enrollment mode
and then holding down the Heat’s
test button until the Heat Alarm
beeps.
5. Remove the mounting plate and
refer to
Sections 2 and 5
for
positioning and installation.
6. After mounting plate is installed
restore the Heat Alarm onto the
mounting plate and fully test the
Heat Alarm per
Section 6
.
Alternate Enrollment Methods
• Scan the Heat Alarm’s bar code
using the Installer app
OR
• Enter the 8-character serial
number on the interactive service
provider’s web portal.
To replace the battery,
detach the
Heat Alarm from its mounting plate
and replace the batteries.
Attention
This manual should be read prior to use and retained for further information.
Use the panel installation guide to verify proper system setup.
Test Heat Alarm
Pull Battery Tab
Position Heat Alarm
12 inches
minimum
12 inches
minimum
RE617 Heat Alarm
™
Encrypted
