INSTALLATION GUIDE
ADESSO DEGREE BATH FILLER
DBFSMC
WHAT IS IN THE PACK
Do not plug outlet when testing.
This mixer is recommended for equal high (mains) pressure water supply only.
Failure to comply with the above will void all warranties.
To ensure the optimum performance and customer satisfaction please adhere to the following:
• Flush out all pipe work prior to installation.
• Minimum flow pressure for satisfactory operation: (Hot and Cold) 150kPa
• Maximum static water pressure: 500kPa. If the water pressure exceeds or is likely to exceed 500kPa, an approved pressure
limiting valve must be fitted.
• Maximum hot water temperature: 60˚C. If the water temperature exceeds 60˚C, an approved tempering valve must be fitted.
• Installation should comply with relevant local authority requirements.
• In accordance with good plumbing practice, filters should be fitted to supply lines to eliminate damage to the ceramic cartridge
from suspended solids.
AS/NZS 3500.1 states that pressures above 500 kPa can cause damage from water hammer, reduce the life of
appliances, taps & fittings, cause excessive noise in the system and recommend that a pressure limiting valve (PLV) be fitted.
•
BEFORE INSTALLATION
Pipework MUST be purged before connecting to the mixer
Supply hoses
Bath filler spout
Brass fitting
Small mounting plate
Protective shell
Bath filler mixer
Spirit level tool
Short base plate
(Concrete install)
Tall base plate
(Wood install)
Dynabolt
(Concrete install)
Large mounting plate
(Wood install only)
Wood screws
Small screws
MINIMUM
MAXIMUM
150kPa
500kPa
55° C
60° C
5° C
N/A
SYSTEM REQUIREMENTS
Equal High (MAINS) Operating Pressures
Operating Hot Water Temperatures
Operating Cold Water Temperatures
