ADDONICS TECHNOLOGIES
Model: CDSC-02
Installation Guide
I.
Hard drive installation
1. Carefully remove the top cover of the Cipher Drive SC by
pressing the latch that can be found on the sides of the
unit.
2.
Connect the 2.5” SATA hard drive firmly onto the
22-pin SATA connector on the tray.
3.
Snap the bottom cover onto the top cover.
II. Connecting Cipher Drive SC to a Computer
1. Insert the smartcard with the contacts facing down into the
Cipher Drive SC
before
inserting the mini USB2.0 or
Firewire 400/800 into the corresponding port on the Cipher
Drive SC.
Note. You may choose to connect the device either via Firewire
or USB2.0.
2.
Insert the USB2.0 or Firewire 800 (or 400) connector to your
computer‟s corresponding port. The unit‟s backlight will turn
on, indicating that Cipher Drive SC has powered up.
III. Using the Built-in Keypad
The built-in keypad allows you to enter/change your PIN (refer to
Authentication and changing PIN). It works on the principle of
capacitive sensing to provide a better user experience and can
detect the presence of a touch on the button.
Note:
The keypad works on the principle of touch and users
need NOT exert force on a button to register a key
pressed.
When pressing the keypad, you will also hear a short
beep indicating that the number press registered with
the device but if you hear a long beep, you will need to
press again that number.
PIN authentication keypad
Smart Card slot
Top cover latch
5V power jack
Mini USB2.0 port
Firewire 800/400 ports
Error LED
Active LED
Status LED
Admin
Button
Change Pin
Button
Enter
Button
ESC
Button
