ABB HSCXT3A-6B Instruction Manual Download

Page: 1 / 14

WARNING: Because of the possible danger to person(s) or

property from accidents which may result from the improper

use of products, it is important that correct procedures be

followed. Products must be used in accordance with the

engineering information specified in the catalog. Proper

installation, maintenance and operation procedures must

be observed. The instructions in the instruction manuals

must be followed. Inspections should be made as necessary

to assure safe operation under prevailing conditions. Proper

guards and other suitable safety devices or procedures as

may be desirable or as may be specified in safety codes

should be provided, and are neither provided by ABB nor

are the responsibility of ABB. This unit and its associated

equipment must be installed, adjusted and maintained by

qualified personnel who are familiar with the construction

and operation of all equipment in the system and the

potential hazards involved. When risk to persons or property

may be involved, a holding device must be an integral part

of the driven equipment beyond the speed reducer output

shaft.

WARNING: To ensure the drive is not unexpectedly

started, turn off and lock-out or tag power source before

proceeding. Failure to observe these precautions could

result in bodily injury.

WARNING: All products over 25 kg (55 lbs) are noted on the

shipping package. Proper lifting practices are required for

these products.

Instruction Manual For

Dodge

6B Hydroil Screw Conveyor Drive

HSCXT3A 6B thru HSCXT7 6B Double Reduction Hydroil Screw Conveyor Drive

for Char-Lynn H, S, T and 2000 Series 6B Spline Motors

These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of
printing. Please see

baldor.com

for updated instruction manuals.

Note! The manufacturer of these products, Baldor Electric Company, became ABB Motors and Mechanical Inc. on

March 1, 2018. Nameplates, Declaration of Conformity and other collateral material may contain the company name of

Baldor Electric Company and the brand names of Baldor-Dodge and Baldor-Reliance until such time as all materials have

been updated to reflect our new corporate identity.

Note:

A Screw Conveyor Drive consists of two sub-assemblies

and a drive shaft all listed below.

1. Reducer

– Includes speed reducer, shaft retainer, retainer

bolt and lockwasher.

2. Adapter Assembly

– Includes adapter bolts, lockwashers,

a lip type seal, 2 braided type seals, a seal retaining ring and
drive shaft key.

3. Drive Shaft

– Includes shaft and key in adapter assembly.

Make certain none of the parts have been damaged in shipment.
Any shipping damage should be promptly reported to the
carrier. Read all instructions in this manual before attempting to
assemble or install the Screw Conveyor Drive. It is important that
assembly be performed in the following sequence and that each
step be completed before continuing to the next.

DRIVE

SHAFT

SEAL

RETAINING

RING

LIP SEAL OR

FELT SEALS

ADAPTER

ADAPTER BOLT

AND LOCK WASHER

SCREW CONVEYOR DRIVE

SPEED REDUCER