ExpWave 240B Secure Outdoor Ethernet Radio Link
8-2
Static Route Setup
Now, enter the index number of one of the static routes you want to configure.
Figure 8-3 Menu 12. 1 — Edit IP Static Route
The following table describes the IP Static Route Menu fields.
Table 8-1 IP Static Route Menu Fields
FIELD
DESCRIPTION
Route #
This is the index number of the static route that you chose in menu 12.
Route Name
Enter a descriptive name for this route. This is for identification purposes only.
Active
This field allows you to activate/deactivate this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number
to be identical to the host ID.
IP Subnet Mask
Enter the IP subnet mask for this destination.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
ExpWave that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as your ExpWave; over the WAN, the gateway must
be the IP address of one of the remote nodes.
Metric
Metric represents the “cost” of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need not
be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Private
This parameter determines if the ExpWave will include the route to this remote node in
its RIP broadcasts. If set to
Yes
, this route is kept private and not included in RIP
broadcast. If
No
, the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to Confirm…”
to save your configuration, or press [ESC] to cancel.
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to CONFIRM or ESC to CANCEL:
