ZyXEL Communications XGS4700 Series, Manual

Page: 100 / 485

Chapter 7 System Status and Port Statistics
XGS4700-48F User’s Guide
100
The following table describes the labels in this screen.
Table 8 Status
LABEL DESCRIPTION
Port This identifies the Ethernet port. Click a port number to display the Port
Details screen (refer to
Figure 36 on page 101 ).
Name This is the name you assigned to this port in the Basic Setting > Port
Setup screen.
Link This field displays the speed (either 100M for 100 Mbps, 1000M for 1000
Mbps, and 10G for 10 Gbps) and the duplex (F for full duplex). This field
displays Down if the port is not connected to any device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP
state of the port. (See
Section 13.1.3 on page 151 for more information).
If STP is disabled, this field displays FORWARDING if the link is up,
otherwise, it displays STOP.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has
been enabled on the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the transmission speed of data sent on this port in
kilobytes per second.
Rx KB/s This field shows the transmission speed of data received on this port in
kilobytes per second.
Up Time This field shows the total amount of time in hours, minutes and seconds
the port has been up.
Clear Counter Type a port number, select Port and then click Clear Counter to erase
the recorded statistical information for that port, or select Any to clear
statistics for all ports.