11
3. Prestige's behavior was unexpected if aggregation was requested in the callback case. It was
because Prestige did not implement callback request and response for BAP (Bandwidth
Allocation Protocol). Prestige has been enhanced to handle callback request and response
for BAP in this release.
4. Prestige used to write Error or Info messages to its system log after ping and telnet finished.
These messages might cause users unnecessary concerns. There will be no more this kind
of messages in system log after this release.
5. Prestige did not respond to HDAP (Host Discovery and Address Assignment Protocol)
requests from PWC (Prestige Web Configurator) any more after its IP address changed. It is
fixed in this release.
6. The information in the call history entry is nonsense if the data in Rate column is blank in
Menu 24.9.4. But Prestige should not show it anyway. Prestige does not show it any more.
7.
My Login
and
My Password
fields for Outgoing call in Menu 11.1 are not required fields
anymore.
8. Add CI command “ip dhcp reset” to clean up the DHCP (Dynamic Host Configuration
Protocol) table. It means that the DHCP will be empty after this CI command.
9. Prestige did not inform far-end its MAC address in IPXCP negotiation. It has been added.
10. Prestige used to route the WAN incoming IP multi-cast packets to default route. Now, it will
drop these incoming multi-cast packets.
11. Prestige will exit from Menu 24.1 after unplug the RS232 cable now.
12. Prestige used to have problems to transfer big files (over 56K bytes after compression) with
Ascend MAX if compression is on. It is fixed.
13. Prestige will negotiate LCP magic number with remote router now.
14. By default, Prestige used to negotiate for PPP VJ slot ID compression, it has been changed
not negotiate for PPP VJ slot ID compression any more.
15. Prestige will send the ICMP redirect packet to the source of the packet if Prestige knows the
gateway, which provides better route from the station to the destination than using Prestige
as the gateway.
16. In Menu 24.1, the value of
Total Outcall Time
is the sum of the outcall time of switched
channels now.
17. The system has been tuned to eliminate some of the MP queue full and Stac compression
sequence error messages even though we could not eliminate all of them.
18. The range of callback timeout has been changed from "5 to 60 seconds" to "1 to 60
seconds".
19. In this release, Prestige will prevent the IP route of a newly added remote node overwriting
the LAN routing entry in routing table.
20. For P128L, the default value for Idle timeout in Menu 11.1 is 0 (infinite) now.
21. In this release, Prestige will drop the link even if the far-end does not respond to Prestige's
request for dropping the link in case BAP used for aggregation negotiation.
22. For eliminating new user's confusion on entering ISP's IP address.
ISP IP Addr
field in Menu
4 is removed.
23. For Denmark ISDN switch, the right ring frequency has now been set in the A/B ports
defaults. You need no longer manually enter the CI command "isdn set initstring s121=2" as
in the past.
6 Known Problem List
1. If both of the POTS port telephones are taken off hook simultaneously while an MP call is in
progress, the Prestige may drop both data channels.
2. If Prestige connects to the switch that does not support in-band tone, the tone will generated
by Prestige instead. In this case, Prestige will send the same tone to both POTS ports. For
example, when telephone 1(telephone connects to POTS port 1) is ringing, off-hooking
telephone 2 (telephone connects to POTS port 2) will cause telephone 1’s sound changing
from ring to dial tone. It is because Prestige generates dial tone for POTS port 2 now.