ZyXEL Confidential
340AGL4C0.doc
19/41
Problem Condition: Step1.in wizard or advanced, select “go to wizard set up”, then
click the “exit” button, it pop up a message “are you sure you want to close the
windows?”, select no, then the page won’t change.
Setp2.but if you select “view device status” or “change password” in wizard, or select
“go to advanced setup” in advanced, then do the same setting with step1, the page will
go to the corresponding page.
22. [BUG FIX] SPRID: 051221229
Problem Symptom: click “modify” button, the local ip and global ip of a full feature
rule will be cleared
Problem Condition: step1. set a full feature rule in
GUI->advanced->network->NAT->address mapping.
step2. click “modify” button, in the following page the local ip and global ip will be
cleared, (if the type of the full feature rule is server, the global ip will be cleared and the
server mapping set will be always change to 2)
step3. if you click “apply”, it only save the type of the full feature but no local ip and
global ip; if you click “cancel”, the configuration of the rule can be show.
23. [BUG FIX] SPRID: 051221226
Problem Symptom: wizard setup page when you set wrong range vpi/vci, you can’t
access the wizard setup page
Problem Condition: step1.login wizard, in “ISP Parameters for internet Access” page,
set up wrong range vpi or vci.
step2.click “next” button, it will show a page with error message “the vpi value must
position between 0~ 255” or “the vci value must position between 32~65535”, and
there is no button to back or exit the page.
step3. when you login the wizard again, you can’t access the wizard setup page.
24. [BUG FIX] SPRID: 051221225
Problem Symptom: wizard setup page, when you select static ip, it show ip address,
static ip address and gateway ip adress, but no subnet mask.
Problem Condition: setp1.login wizard, in “ISP Parameters for internet Access” page,
select encapsulation = enet encap
step2.click “next” button, then select static ip, it show ip address, static ip address and
gateway ip address, but no subnet mask. in fact the static ip address is the subnet mask.
25. [BUG FIX] SPRID: 051221216
Problem Symptom: static routing rule #2~ rule #16 can’t work if you click the “apply”
button
Problem Condition: step1. GUI->advanced->static routing, in rule #2 and rule #16 set
one rule and active it
step2. click “apply” button, then refresh the page, go to GUI->advanced->static routing,
the rule will change inactive, rule #1 will change active, although you don’t set the rule
#1. and the setting rule can’t work.
step3. But if you don’t click the“apply”button and don’t refresh the page, it can work
correctly.
