ZyXEL Communications P-2302HWL DECT USB, Quick Start Manual

Page: 4 / 16

P-2302HWUDL-P1 Quick Start Guide
4
5 USB 2.0 : Use a USB cable (not provided) to connect a USB (version 2.0 or lower) printer to this port.
6 USB 2.0: Connect a USB (version 2.0 or lower) memory stick for file sharing. The P-2302HWUDL-P1
automatically detects the USB device.
7 Use the power adaptor provided with your P-2302HWUDL-P1 to connect an appropriate power source to
this socket.
Look at the lights on the side panel of the P-2302HWUDL-P1.
• The POWER light blinks during start-up and is green once the P-2302HWUDL-P1 is ready.
• Each ETHERNET light turns on if the corresponding ETHERNET port is properly connected.
The lights blink when the P-2302HWUDL-P1 is sending or receiving data through the corre-
sponding
ETHERNET port.
• The WAN light stays on if a physical connection with your DSL modem exists and blinks when
transmitting data. The INTERNET light stays on when Internet access is available.
• The PHONE lights stay on when your SIP account is registered and they blink if the receiver is
off the hook.
• The WLAN light turns on when the wireless LAN is ready. It blinks when the P-2302HWUDL-P1
is sending/receiving data through the wireless LAN.
• The USB light turns on when there is a USB device (printer or memory stick) connected to the
P-2302HWUDL-P1.
If PHONE 1 or PHONE 2 light is on, skip to Section 5.2 to see how to make calls through the
Internet.
If the INTERNET light comes on but the PHONE lights are off, go to Section 5 and use the
VOIP SETUP wizard.
If the INTERNET light is off but the WAN light is on, go to Section 4 and use the CONNECTION WIZARD to
configure your Internet access settings.
If the lights are different than described, go to Troubleshooting .
3 DECT Phone Registration
In order to use your DECT phone with the P-2302HWUDL-P1, the DECT phone must register with the P-
2302HWUDL-P1’s DECT base station. Take the following steps to register your DECT phone with the P-
2302HWUDL-P1.
1 Press down the DECT base station button ( A ) on top of your P-2302HWUDL-P1 for 6 to 11 seconds. When
the LED light of the DECT base station button begins to blink , the P-2302HWUDL-P1 is in registration
mode. The P-2302HWUDL-P1 in registration mode for 25 to 30 seconds. Your DECT phone must be
registered within the time period.