ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite, User Manual

Page: 58 / 84

Omni.Net Lite User’s Guide
57 Chapter 3 Using AT Commands
W2 Display user data.
W3 Display phone number of calling site and user data.
X Enable/Disable extended result code.
X0 Basic result code (default).
X1 Extended result code.
Z Reload user-defined profile.
&C DCD signal control.
&C0 Follow DTR signal.
&C1 ON only if in communication (default).
&D DTR (Data Terminal Ready) signal control.
&D0 Ignore DTR signal, assume DTR is always ON.
&D1 DTR OFF-ON transition causes dial of an outgoing call using the
first pre-stored phone number.
&D2 DTR OFF causes the modem to hang up (default).
&F Restore the factory default.
&K Set flow control mode.
&K0 Disable flow control.
&K3 Enable CTS/RTS flow control (default).
&K4 Enable XON/XOFF flow control.
&S DSR (Data Set Ready) signal control.
&S0 Follow DTR signal (default).
&S1 Follow DCD signal.
&V Display all data parameters settings.
&W Save current parameters setting, include &-leading and non-
leading parameters, as user defined profile.
%D0=n Select DTE baud rate when system is powered on.
n=8: 9600 bps
n=11: 19200 bps
n=13: 38400 bps
n=16: 57600 bps
n=17: 115200 bps (default)
n=21: 230400 bps
%D1=n Select DTE attribute when system is powered on.
n=0: 8 data bits, non parity (default)
n=1: 7 data bits, even parity
n=2: 7 data bits, odd parity
%D2=n Dial an outgoing data call automatically if there is pre-stored
dialing number after system is powered on.
n=0: do nothing (default)
n=1: auto-dial after power on
Table 14 AT Data Command Sets Requiring an "AT" Prefix
COMMAND OPTION DESCRIPTION