ZyXEL Communications G-220 v3, User Manual

Page: 76 / 125

ZyXEL G-220 v3 User’s Guide
76 Chapter 5 Access Point Mode Configuration
5.1.2 Additional Setup Requirements
To bridge your wired and wireless network using the G-220 v3, the following requirements
must be met:
1 The G-220 v3 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to Appendix B on page 89 for an example).
3 Set the wireless station’s IP address to be dynamic if you want the wireless stations to
access the wired network or the Internet through the G-220 v3. Refer to
Appendix E on
page 111 for how to configure your computer’s IP address.
5.2 The Link Info Screen
Select the AP Mode check box and wait for about five seconds to display the screen as shown.
Figure 48 Access Point Mode: Link Info
The following table describes the labels in this screen.
Table 16 Access Point Mode: Link Info
LABEL DESCRIPTION
Status
SSID This field displays the name that identifies your G-220 v3 in the wireless LAN
network.