ZyXEL Communications ADSL/ADSL2/ADSL2+ Router 660R-6xC Series, User Manual

Page: 66 / 282

Prestige 660R-6xC Series User’s Guide
65 Chapter 6 WAN Setup
6.6 Traffic Redirect
Traffic redirect forwards traffic to a backup gateway when the Prestige cannot connect to the
Internet. An example is shown in the figure below.
Max Idle Timeout Specify an idle time-out in the Max Idle Timeout field when you select Connect
on Demand . The default setting is 0, which means the Internet session will not
timeout.
PPPoE Passthrough This field is available when you select PPPoE encapsulation.
PPPoE +
PPPoE_Client_PC
(PPPoE
encapsulation only)
In addition to the Prestige's built-in PPPoE client, you can enable PPPoE pass
through to allow up to ten hosts on the LAN to use PPPoE client software on their
computers to connect to the ISP via the Prestige. Each host can have a separate
account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
Subnet Mask
(ENET ENCAP
encapsulation only)
Enter a subnet mask in dotted decimal notation.
Refer to
Appendix C IP Subnetting in the to calculate a subnet mask If you are
implementing subnetting.
ENET ENCAP
Gateway
(ENET ENCAP
encapsulation only)
You must specify a gateway IP address (supplied by your ISP) when you select
ENET ENCAP in the Encapsulation field
Back Click Back to return to the previous screen.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.
Table 11 WAN Setup (continued)
LABEL DESCRIPTION