Touchscreen User Manual – Issue 1
Zytronic X-Y Controller (Serial and USB)
27
4.0
QUICK CONFIGURATION OF THE UPDD DRIVER AND PROJECTED
CAPACITIVE X-Y CONTROLLER TOUCHSCREEN
This section of the manual describes how to quickly configure the main parameters of the UPDD
Driver and Projected Capacitive X-Y Controller Touchscreen. The example described below is based
on a USB controller, however the procedure is the same for a Serial controller.
Note:
It is recommended that a mouse be used for the initial setting up of the touchscreen parameters.
4.1 Launching the UPDD Console and setting up the Touchscreen
To begin the configuration procedure of the Zytronic Projected Capacitive X-Y Controller
Touchscreen, the user must launch the UPDD Console. The UPDD console is the main interface used
to configure the functionality and performance of the Zytronic Projected Capacitive X-Y Controller
Touchscreen. To launch the UPDD Console carry out the following:
1.
Click on the Windows
Start
button.
2.
Go to
Programs
and locate the
UPDD
folder.
3.
Within the
UPDD
folder click on the
Settings
shortcut link.
This will open the UPDD Console, as shown in Figure 24.
Figure 24:
UPDD Console
The UPDD Console has five main pages;
Hardware
,
Click Mode
,
Properties
,
Calibration
, and
Status
, list down the left hand side of the console window. Each of these five main pages has
parameters that can be altered by the user to select and set different parameters of the touchscreen.
All parameters are described in detail in Section 5.0 of this manual.
What this section of the manual will concentrate on is the very basic steps to get the touchscreen up
and running. These steps are outlined below.