Dimensional Data (inches and [ mm ]) are Subject to Manufacturing Tolerances and Change Without Notice
Zurn Industries, LLC
|
Specification Drainage Operation
1801 Pittsburgh Avenue, Erie, PA U.S.A. 16502 · Ph. 855-663-9876, Fax 814-454-7929
In Canada
|
Zurn Industries Limited
3544 Nashua Drive, Mississauga, Ontario L4V 1L2 · Ph. 905-405-8272, Fax 905-405-1292
www.zurn.com
®
Rev.
B
Date:
5/9/2018
C.N. No.
140014
Form No. FT628
Page 8 of 9
Z884
SHALLOW TRENCH DRAIN SYSTEM™
INSTALLATION INSTRUCTIONS
POURING THE CONCRETE
It is necessary to install a 4-1/4" [108mm] wide spacer (supplied by others) in the grate section of the trench to maintain the
width during the concrete pour.
Pour the concrete around the three sides of the trench drain. Be certain to adequately VIBRATE the concrete as it is being
placed. Proper vibration will eliminate any unwanted voids within the concrete pour.
Finish troweling should be done to set the top edge of the trench drain about 1/16” [2mm] below the floor grade. Remember to
compensate for concrete shrink that may occur during cure so that the edge of the trench drain does not protrude above the
finished floor grade.
