Removal and Installation
of (#1, #5, and #6) Pins
1. If necessary, pins can be removed
by placing a punch on the round,
smooth side of the pin and tapping
with a hammer.
2. To install new pins, line up the
pathway with a small screwdriver,
insert the round smooth end of the
pin into the hole and tap the knurled
end of the pin with a hammer until
the pin is flush with the surface.
Removal of Existing
E-Clip (#4) and
Adjustment Pin (#3)
1. With the handles fully open, make
note of the adjustment number on
the Pin (#3) facing the dot on
the tool.
2. Remove existing E-Clip (#4) by
prying it away from the pin with a
flat head screw driver or needle
nose pliers.
3. Tap the adjustment pin (#3) out as
far as you can with needle nose
pliers then remove pin by hand
using a pulling/wiggling motion.
Installation of New
E-Clip (#4) and Adjustment
Pin (#3)
1. Clean the adjustment pin area
of the tool with a brush and rag
to remove any dirt and surface
rust. Be careful not to remove the
adjustment dot marking on the tool.
2. Use a ratchet bar
clamp to close
the jaws until the
hole in the jaw
clears the hole in
the tool. Move the
upper handle to
align its hole with the hole in the
jaw. Insert the adjustment pin (#3)
into the aligned holes, positioning
the pin so the appropriate number
is facing the dot on the tool. Jiggle
the handle until the pin seats fully
into position and the groove on
the other side of the pin clears the
surface of the tool.
(continued on next page)
Kit Includes:
1. Upper and Bottom Handle Large
Pins, Qty. 3
2. Middle Handle Pin with 2 E-Clips,
Qty. 1
3. Adjustment Pin, Qty. 1
4. Adjustment Pin E-Clip, Qty. 1
5. Ratchet Bar Pin, Qty. 1
6. Upper Handle Small Pin, Qty. 1
INSTALLATION INSTRUCTIONS
QCRTQCMRKIT - Repair Kit
For QCRTQCM - Medium QickClamp
®
Crimp Tool
1
1
6
1
2
4
5
3
4
3
5
1
1
6
1
2
Watch our
on our One Zurn YouTube Channel.
