FV38-WCS • Page 2
Figure 1
PRIOR TO INSTALLATION
Prior to installing the Zurn Automatic Sensor-equipped Flushometer,
install the items listed below as illustrated in Figures 1 through 4.
• 2-gang electrical box (4 x 4 x 21⁄8 use Steel City #52171-N
box and #52-C-18 device cover or equivalent for sensor); see
paragraph entitled “Sensor Location.”
• Single-gang electrical outlet for plug-in power converter.
• Electrical wiring to the power converter outlet (120 VAC,
35 watts service required for each power converter used).
• Closet fixture.
• Zurn carrier system, Z1200 series or equal.
• Single-gang box for Low Battery Indicator Light (optional).
IMPORTANT:
• All electrical wiring is to be installed in accordance with
National/Local codes and regulations.
• All plumbing is to be installed in accordance with applicable
codes and regulations.
• Water supply lines must be sized to provide an adequate volume
of water for each fixture.
• Flush all water lines prior to making connections.
• Sensor units should not be located across from each other or
in close proximity to highly reflective surfaces.
The Zurn AquaVantage is designed to operate over the entire
pressure range recommended by plumbing fixture manufac turers
and will produce a metered flush when activated.
Protect the chrome or special finish of this AquaVantage.
Do not use toothed tools to install or service the valve.
Also, see “Care and Cleaning” section of this manual.
SENSOR LOCATION
(Figures 1 and 2)
Models ZEMS6000, ZEMS6140, ZEMS6142 and ZEMS6152
Locate the 2-gang electrical box on the centerline of the Flusho -
meter and 21" above the top of the closet fixture (use Steel City
#52171-N box and #52-C-18 device cover or equivalent).
Models ZEMS6000-2 and ZEMS6000-3
Locate the centerline of the 2-gang electrical box 3-1/4" to the left
of the centerline of the Flushometer and 15" (Model ZEMS6000-2)
or 17" (Model ZEMS6000-3) above the top of the closet fixture. (Use
Steel City #52171-N box and #52-C-18 device cover or equivalent).
All Models
NOTE:
Install plaster ring so screw holes are on left and right side
of box. Trim tiles to allow screw holes in plaster ring to show.
