FV743 Rev. D 07/02/21
Page 4
FV743 Rev. D 07/02/21
Page 3
2. Install spout to sink using spout base gasket, plastic mounting
washer, star washer and mounting nut.
Note: Faucet location needs to be within 3 feet radius above
electrical outlet for ACA configurations.
NOTE
: Before installation, turn off water supplies to existing faucet and remove faucet if replacing an existing device.
Clean the faucet basin and clear away debris. Flush all supply lines before connecting the faucet. Failure to do so
may result in debris clogging the inlets and/or internal control and mixing valve
1. Carefully screw aerator into spout using included tool.
Take care to not pinch blue o-ring
3. Ensure that slot in plastic washer is facing forward.
Sensor cable should not pass through plastic mounting washer.
Spout Installation Instructions
Z6920-XL-W1
Z6922-XL-W1
1.a. Install endpoint on wall surface within 2 feet radius of faucet
with dry wall anchors & screws or doubled sided VHB tape
1.b. For concealed wiring installation, drill 3/16” hole in wall surface
for DC power cable , route wire-end through hole to HW6 unit.
After routing, apply sealant around wire in hole.
Endpoint & Electronic Module Installation Instructions
4. Connect Y-cable to electronics module assembly
5.b. Optional HW6 (Hardwired 6V) version: Connect supplied inline
connector and hardwire adapter. When securing the CWB wires
to the screw terminals on HW6 unit, the BLACK WITH DASHED
MARKINGS should be connected to the Positive (+) terminal, and
the SOLID BLACK wire should be connected to the Negative (-)
terminal.
BLUE
(-)
GREE
N/YE
LLOW
FRAM
E/SA
FETY GROUND
P6000-HW6 WIRING
IN
VAC
(LINE)
BLAC
K
(NEUTRA
L)
WHIT
E
RED (+
)
-CWB
-HW6
2. Connect endpoint and DC power cable.
Electronics Box with
Ceramic Valve
3. Tighten electronics module assembly to shank and connect
water line(s).
5.a. ACA version: Plug in AC adapter to wall outlet.
ACA
Do not connect Y-cable to the spout.
