FV808 Rev. A 09/07/21
Page 14
8. Ensure that sink is clear of tools/debris and is in normal
operating condition. Remove protective film from sensor lens if one
is present.
9. Turn on water supply(ies).
7.
Tighten electronics module assembly with the hydrogenerator
to shank and connect water line(s).
10. Connect sensor cable from spout to monitor.
• Do not use any abrasive or chemical cleaners to clean the faucets. Do not use any cleaners with an acid base.
•
If abrasives or chemicals are used it can lead to dulling of luster, attacking of chrome plating or decorative finishes.
• ONLY use mildly warm soapy water, and then wipe the device dry with a clean/soft towel or cloth.
•
Upon cleaning other areas of the restroom be sure the sensor lenses are protected from other cleaning chemicals/solvents to prevent
potential damages to the sensor and/or electronics.
Care and Cleaning Instructions (All Configurations)
