White wire RX-Signal
Red wire RX+6.0V
Black wire RX-
When using a Sensored Brushless motor, the Blue motor wire (A), Yellow motor wire (B) and Orange motor wire (C) of the ESC must be connected with the
Sensored motor wire terminals (A,B,C) respectively. It is necessary to connect the Sensor wire to the “Sensor” socket on the ESC. Do not change the
sequence of the wires.
Sensored Mode
When using a Sensorless Brushless motor, the Blue motor wire (A), Yellow motor wire (B) and Orange motor wire (C) of the ESC must be connected with the
Sensorless motor wire terminals (A,B,C) respectively. Do not change the sequence of the wires.
Sensorless Mode
Note: If the motor operates in reverse rotation, this can be changed in the programming settings.
Connection to Rx
LED Indication
Hold the switch
The red and blue
are on solid
2 Seconds
The red off
blue on solid
Release the switch
Red,blue Led blink
for 1 second then go solid,
motor
“
~beep~beep~beep~”
Step one
Push
trigger to
full brake
Red
led
blink for
3 seconds then
go
on solid,motor
“~
beep
~
”
Pull
trigger to
full throttle
Blue
led
blink for
3
seconds then
go
on solid,motor
“~
beep
~
beep~”
Release trigger to
neutral position
Step three
Holding the “Switch” button over
2 seconds will turn off the ESC
Step two
Throttle Range Calibration
Function
Low voltage of the battery
Over-heat of the ESC and motor(95
℃
)
Sensored Mode
Sensorless Mode
LED
Red LED
Blue LED
Red and Blue LED
Blue LED
LED Status
Blinking
Blinking
ON
ON
