Chapter 2 - Product Installation
Parameter
Description
IP Subnet Mask
Enter the W300 IP subnet mask. By default, it is 255.255.255.0.
Dynamic Route
Select the Routing Information Protocol (RIP) to be used from the
dropdown list. And select the direction from the dropdown list
Multicast
Select the multicast protocol to be used from the dropdown list
DHCP
DHCP function can be disabled, enabled or in relay mode. Figure 13 shows
the parameters when DHCP is enabled. And Table 13 gives the parameter
descriptions.
T
A B L E
1 3 T
H E
D
E S C R I P T I O N S
O F
T H E
D H C P P
A R A M E T E R S
Parameter
Description
Starting
IP
Address
Enter the starting IP address to be used by the DHCP server’s IP
assignment. By default, the starting IP address is 192.168.1.2
and the ending IP address is 192.168.1.254.
IP Pool Count
Enter the maximum user pool size to be assigned.
Lease Time
Enter the amount of time to lease out a given IP address.
DNS Relay
Select the DNS relay option to be used from the dropdown list. If
the users do not want to use the DNS relay option, set the DNS
relay to “Use User Discovered DNS Server Only” and set both
Primary and Secondary DNS servers to 0.0.0.0.
Primary DNS
Server
Enter the primary DNS server IP address to be used. For user
discovered DNS only.
Secondary DNS
Server
Enter the secondary DNS server IP address to be used. For user
discovered DNS only.
A DHCP relay is a computer that forwards DHCP data between computers
that request IP address and the DHCP server that assigns the IP address. If
the DHCP Relay option is enabled, DHCP requests from local PCs will be
forwarded to the DHCP server that runs on WAN side. For this function
working properly, W300 must run on the router mode, disable the DHCP
server on the LAN port and make sure the routing table has the correct
routing entry.
Proprietary Information of ZTE CORPORATION
25
