6.
Select
Search
in the
Services Settings
page to find nearby AP. After that, select an AP.
7.
Set the following parameters: authentication mode, encryption mode, encryption key, encryption
key ID. After settings, select
Next
.
Note:
Different AP needs to set different parameters. Set the parameters according to the on-site de-
mands of AP.
8.
Set network parameters.
Select an access mode according to the network situation.
Access Mode
Parameter Description
PPPoE
�
User
: ADSL username
�
Password
: ADSL password
DHCP
It is not necessary to set any parameters. The STB gets the parameters (such
as IP address, gateway) automatically.
LAN
�
IP Address
: IP address of STB
�
Mask
: Subnet mask of STB
�
Gateway
: Gateway of STB
�
DNS Server
: DNS address of STB
9.
After settings, select
OK
to return to the
Configuration
page and reset the STB.
10. After resetting, the STB connects to EPG server if the parameters are correctly set.
Note:
Make sure that the AP runs normally before reset.
Checking Signals
After wireless configuration, you need to check wireless signals according to the following procedure:
1.
Press
SET
to enter
Configuration
page.
2.
Use direction buttons to select
Network Information
. Enter the
Network Information
page.
Observe the wireless signal status according to
WLAN Status
,
WLAN Intensity
.
Signal Intensity
Signal Status
0 - 34
Poor
35 - 54
Medium
21
