Zte ZXHN H267N, Management Manual

Page: 49 / 112

Chapter 3 Configure the Internet
Parameter Description
Service Type The service type of the application, including TCP , UDP ,
and TCP AND UDP .
The default service type is TCP .
Trigger Port The port that the application uses.
Connect Type The connection type that is used to connect the outside,
including TCP , UDP , and TCP AND UDP .
The default service type is TCP .
WAN Port Range Specify the port range of the device protocol that the
triggering port maps, that is, the layer-4 port number of
the packets.
Once the device accesses the triggering port, the service
between the start port and end port will be enabled.
The WAN Start Port and WAN End Port must be specified
and meet the following conditions.
l The end port number is larger than the start port
number.
l
The difference between the end port number and the
start port number is less than nine.
Timeout The time when no traffic occurs.
3. Click Apply button to apply the changes.
– End of Steps –
3.5 Configure the DDNS
The section describes how to configure DDNS . DDNS provides the parameters of DDNS
configuration function.
Steps
1. On the main page of the ZXHN H267N, select Internet > DDNS to go to the DDNS
page, the page as shown in Figure 3-27 .
3-33
SJ-20140702105807-002|2014-11-13 (R1.0) ZTE Proprietary and Confidential