ZSK Automatic Bobbin Winder, Operating Manual

Page: 20 / 26

1-20 •
02418V10 • 11.08.2016/DC
Troubleshooting
1.11 Troubleshooting
Fault Cause Remedy
Bobbins have been fi lled
irregularly (one-sided).
Direction of the thread shake
down in the bobbin is one-sided.
Check left-right-justifi cation of
yarn guide. The position of yarn
guide has to be verical over the
bobbin support.
Empty bobbins will not be
delivered to the bobbin support
during the winding process.
Buzzer sounds.
1. Bobbins are clamped in the
bobbin depot and did not
slight into the lower guidance
groove.
2. Empty bobbin depot.
1. Put a pin in the borehole
of bobbin depot and rotate
carefully the cover in one
direction. The clamped
bobbins have been loosened
and the bobbins slide into the
lower guidance groove again.
2. Fill in new bobbins.
Buzzer sounds. 1. Thread breakage.
2. Empty yarn cone.
3. Empty bobbin depot.
4. Bobbins locking thread cutter.
1. Threading winder again.
2. Use new yarn cone, threading
winder again
3. Fill in new bobbins.
4. Check bobbin ejection skid,
if necessary eleminate bobbin
jam.
Device don‘t turn on with rocker
switch (rear side).
Sicherung(en) defekt. Change fuse(s).