©2022, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
5
While operating the Zortrax Curing Station, all measures regarding health and safety that are
provided in this User Guide as well as in separate regulations should be taken into account.
If the device begins to operate in an unidentified way, safely unplug it from the power source
and immediately contact the Manufacturer through the support form at:
Electrical Safety
Zortrax devices have been tested for compliance with Low Voltage Directive. In order to ensure
the highest safety standards, including protection against short circuit, overload, overvoltage
and device overheating, do not attempt to modify the device and do not use electronic
replacement parts other than those recommended by the Manufacturer.
Before plugging the power cable into the outlet, make sure that the power supply voltage in
the outlet matches the required value provided on the nameplate at the back of the device.
Avoid overloading the outlet with too many devices.
The device must be well-grounded. Always make sure that the ground complies with local and
national regulations.
Use only the original power cable supplied with the device. Do not damage, cut or repair the
cable. A damaged cable should be immediately replaced with a new one. The cable should be
used according to its intended purpose and should be protected from heat, oils, sharp edges
and moving components of the device. A damaged cable increases the risk of an electric shock.
All maintenance and repair work should be carried out while the device is off and unplugged.
Modifications such as soldering of electronic subunits are forbidden.
Mechanical Safety
The Zortrax Curing Station has movable components, such as the glass table. Therefore, it
is forbidden to reach into the device or put anything inside the device when it is running or
about to start running. This may lead to serious injuries or damage.
Tools and accessories delivered with the device should be used with special care only for
intended purposes. Improper use may cause serious injuries.
While following post-processing procedures, wear safety gloves and glasses to avoid
injuries that may be caused by sharp edges and fragile elements of models.
