FACTORY RESET
When your network
’
s primary controller is missing or otherwise inoperable, you may need to reset the
device to factory settings manually. To complete the process, make sure the Water Sensor is powered on,
then PRESS AND HOLD the Z-Wave button for AT LEAST 10 SECONDS until the LED indicator flashes ONCE.
Release the button. NOTE: All previously recorded activity and custom settings will be erased from the
device
’
s memory.
MOUNTING
There are 2 ways to install the Water Sensor:
1. Simply place the sensor on flat surface which you want to monitor for leaks. It can be the floor in your
laundry room or kitchen cabinet under the sink.
You don’t need to use the external probe or mounting bracket for this installation. This is great for spaces
where you expect dripping rather than flooding.
NOTE: Check that all 3 foot probes are touching the surface.
OR
2. Use the mounting bracket to install the sensor on a wall above the ground where you want to monitor
leaks or water level.
- Once you determine the perfect spot, fix the bracket to the wall with the supplied screw
- Place the sensor in the bracket fitting the foot probes into the round metal contacts
- Plug the external probe into the sensor and make sure it lays flat on the floor. Test the device
This installation is great for spaces which may get flooded, such as basements or boiler rooms.
WARNING
- This product should be installed indoors upon completion of any building renovations
- Prior to installation, the device should be stored in a dry, dust-and-mold-proof place
- Do not install the Water Sensor in a place with direct sun exposure, high temperature or humidity
- Keep away from water, chemicals, and dust
- Ensure the device is never close to any heat source or open flame to prevent fire
- No part of the device may be replaced or repaired by the user, except for battery change
Z-WAVE PLUS CERTIFIED
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices
from other manufacturers and/or other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the network.
