ADVANCED SETTINGS
If your controller’
s software allows for advanced configuration and parameter adjustment, you will be
able to change and save the settings below and customize the Water
Sensor’s performance to serve your
needs.
Total Alarm Duration
Parameter 1: Use this parameter to set the total duration of audio and visual alarm each time water is
detected. If the value is set to 0, the alarm will continue until water is no longer detected. Use parameters
2
–
4 to customize the alarm.
Values: 0
–
255 (minutes). 120
–
default setting.
Size: 1 byte dec.
Audio Alarm: Beep Interval
Parameter 2:
Set the beeping frequency for the sensor’s audio alarm.
The interval between beeps can be
as low as 1 minute.
Values: 1
–
255 (minutes); 1
–
default setting.
Size: 1 byte dec.
Audio Alarm: First Beep Duration
Parameter 3: Adjust the duration of the initial sound the alarm will produce after a leak is detected.
Values: 10
–
255 (seconds); 60
–
default setting.
Size: 1 byte dec.
Audio Alarm: Beep Duration
Parameter 4: Adjust the duration of the beeps the alarm will sound after a leak is detected and the first
“long” beep is produced
.
Values: 5
–
255 (seconds); 5
–
default setting.
Size: 1 byte dec.
Enable / Disable Audio Alarm
Parameter 5: Enable or disable the audio alarm by adjusting these parameter settings. The visual alarm
will NOT be disabled and the LED indicator will always light up each time water is detected.
Values: 0
–
alarm disabled; 1
–
alarm enabled (default setting).
Size: 1 byte dec.
