5. A new on / off device should be recognized by your Z-Wave controller
Secure Z-Wave Inclusion
1. Plug the smart plug into a grounded receptacle located within 3 feet from your Z-Wave
gateway controller
2. Put your Z-Wave controller in secure inclusion mode
3. Press and HOLD the Z-Wave button for at least 3 seconds
4. LED indicator will flash green
5. LED indicator will turn solid green once the inclusion is completed. Please allow 5 minutes
for configuration. DO NOT press any buttons or move the device during that time
6. A new secure on / off device should be recognized by your Z-Wave controller
Q: I have not been able to add the device to my network after several attempts. What do I do
now?
A: If you are unable to include the Z-Wave smart plug to your controller, please try one of the
following:
- Bring the smart plug closer to your Z-Wave controller
- Press and release the Z-Wave button quickly more than 3 times once you put the controller
in the inclusion mode to ensure the command has gone through
- Put your controller in the EXCLUSION mode and press and release the Z-Wave button
quickly 3 times, then try adding it to your network again
- If you are trying to include the device as a secure one, please make sure your controller
supports AES signal encryption
Z-WAVE EXCLUSION
1. Plug the smart plug into a grounded receptacle located within 3 feet from your Z-Wave
gateway controller
2. Put your Z-Wave controller in exclusion mode
3. Press and release the Z-Wave button 3 TIMES QUICKLY
4. LED indicator will flash orange
5. The smart plug should disappear from your controller's device list and LED indicator will
remain solid orange for a few seconds to indicate exclusion
Please repeat the process following all steps carefully if the first attempt is unsuccessful
FACTORY RESET
When your network’s primary controller is missing or otherwise inoperable, you may need to
reset the device to factory settings manually. In order to complete the process, plug the smart
plug into a grounded receptacle, then PRESS AND HOLD the Z-Wave button for AT LEAST 20
SECONDS. The LED indicator will stay solid yellow for 2 seconds to indicate successful reset.
The plug will then automatically turn off.
NOTE: All previously recorded activity and custom settings will be erased from the device’s
memory. You may only reset your smart plug once it has been included to a Z-Wave network.
ASSOCIATION
Depending on your Z-Wave gateway's home automation software capabilities, you may be
able to associate your smart plug in groups with other Z-Wave devices to schedule scenes
and create events. This smart plug supports Group 1 with up to five devices for lifeline
communication. This device will send BASIC REPORT to Group 1 when operated manually.
