45
FUNCTION
Key
Settings
• Pad push/release detection timing during groove play
The following 9 settings are available for the quantize value.
Setting Range: 0 - 99 (Default value: 70)
The volume level of the metronome click sound heard during real-time recording can be adjusted with
the [VALUE UP/DOWN] keys.
This setting applies to all patterns.
Setting Range: 1 - 99
Sets the length of the pattern in the range from 1 - 99 measures. Changing the length of an already
recorded pattern is also possible, but the recorded sound will change as follows. Proceed with care,
especially when making the number of measures smaller.
■
Making the number of measures larger
Blank measures are added to the end of the pattern.
■
Making the number of measures smaller
The excess measures at the end of the pattern are cut off. Once the [FUNCTION] key is pressed to
accept the setting, it will not be possible to restore the cut-off measures.
Sets the function of the foot pedal FP01 or foot switch FS01 connected to the [CTRL1 IN]/[CTRL2 IN]
jacks on the rear panel.
■
When FP01 is connected
Press the [FUNCTION] key and then pad 9 [CTRL ASSIGN], and move the pedal to enable the
setting. After the function is selected with the [JAM FUNCTION] key, the FP01 can then be used in
Setting the metronome volume level (CLICK VOL)
Setting the number of measures for a pattern (BAR LENGTH)
Selecting the foot switch/foot pedal function (CTRL ASSIGN)
4 ...........................Quarter note
8 ............................Eighth note
12 .................Eighth triplet note
16 .......................Sixteenth note
24 ............Sixteenth triplet note
32 ................Thirty-second note
48 .....Thirty-second triplet note
Hi ...........Quantize function off
During step recording:
1 tick (1/96 quarter note)
• Even when the quantize value is set to Hi, the [REPEAT/STEP]
key interval is a thirty-second note.
• The quantize value cannot be set separately for each track.
NOTE
The RhythmTrak
•••
234 stores this setting for each pattern
individually.
HINT
HINT
The intensity with which you tap the pad to set up the FS01
determines the volume level of the sound produced when you press
the FS01. The volume is affected by the pad sensitivity setting
(PAD SENS).
HINT
HINT
