2
Setting Up the AP+4
1
Open your Web browser, enter
10.0.0.200
in the address
bar, and press the
Enter
key to open the Zoom AP+4
configuration software. The
Status
page appears first.
2
In the left pane, select
Setup Wizard
.
3
On the
Welcome
page, click
Next
.
4
On the
Choosing an Operating Mode
page, select the way
you want to use the AP+4:
•
Router/Access
Point
•
Ethernet
Client
•
Wireless
ISP
Router/Access Point
. In this mode, which is the one most
users will select, the AP+4 links all wireless-enabled
computers and other devices to a network and gives those
devices shared access to your broadband Internet
connection.
In the unlikely event that you are using the AP+4 as a
Repeater, on the
Wireless Basic Setup
page at the
Mode
option, select
AP+WDS
. Then, on the
WDS Settings
page,
enter the MAC addresses of access points you are
communicating with.
Ethernet Client
. This mode lets up to four computers, game
consoles or other devices plug into the AP+4 for wireless
access to a wireless network. (In this mode, the AP+4 acts
as a full bridge, just passing data back and forth between the
Internet and network devices.)
Wireless ISP
. In this mode, the AP+4 connects to the
Ethernet ports of up to four wired PCs or game consoles,
and connects those devices wirelessly to a wireless access
point. Use this mode if you know you need to use the AP+4's
NAT functionality. Most users who need to connect a
computer or game console to an access point should set up
the AP+4 as an Ethernet Client instead.
If you select Wireless ISP mode, use the
Wireless Basic
Setup
page to configure the AP+4 as a wireless client.
Click
Next
to continue.
