Z
S
I
-
4
5
0
-
I
P
CONTROL_MODE
The control mode value allows the user to choose between two different control modes. If the control mode is
set to 0, then the communications for the remote site will be via the active-x control that is running on the ZSI-
450-IP. In most cases this would mean that no extra telemetry is sent to the remote site other than those
listed in the supported IP interfaces document which is available from Meyertech. Alternatively, if the control
mode is set to 1 then the control mode is set up as remote site control. This requires a ZSC-250-IP at the
remote site and any extra telemetry will be forwarded via IP to the ZSC-250-IP unit. This method allows for
complete control of the remote site.
DVR_MODE
The DVR mode value allows the user to specify the type of DVR that is to be used for this site. The values
that are used are in appendix 1 at the end of this document.
DVR_ADDRESS
The DVR address value allows the user to specify the name or the IP address of the remote DVR to connect
to.
DVR_PORT
The DVR port value is not used by all of the DVR’s (only Vista Columbus and Neurodynamics) but it is used
to specify the socket number to connect to on the remote DVR.
ZONEVU_ADDRESS
The ZoneVu address value and the ZoneVu port value are only used if the control mode is set to 1 (for
remote site control). The address value specifies the name or the IP address of the remote ZSC-250-IP to
connect to.
ZONEVU_PORT
The port value is used to specify the port to which the connection is made on the unit.
