ZoneVu ZoneVu ZVK-77D, User Manual, Page: 29 / 41

ZVK-77 User and Configuration Manual Issue 08 Page 29 of 41
IO base address The MAC address used by the 1
st
ZVS-IOM8 unit on the system. Do not modify this
setting without referring to Meyertech Technical Support.
12
Mode
Can be set to either
Site mode
or
Classic mode
. If set to
Classic mode
will not allow the
operator access to Site mode , but will replace it with Classic mode – which uses the
same menus without the ability to access remote sites.
Site mode
•
Seq. access
Controls operator access to sequences.
Description Default
Edit access
level:
Select the required operator level – user, manager or engineer – for controlling the currently
highlighted sequence number.
User
•
Relay Config
The ZVK-77 will control the ZVS-IOM8 units via the Relay Mode . The text description for each relay on the ZVS-
IOM8 can be configured.
Description Default
Relay 1 Relay 1
Relay 2 Relay 2
Relay 3 Relay 3
Relay 4 Relay 4
Relay 5 Relay 5
Relay 6 Relay 6
Relay 7 Relay 7
Relay 8 Relay 8
Relay 9 Relay 9
Relay 10 Relay 10
Relay 11 Relay 11
Relay 12 Relay 12
Relay 13 Relay 13
Relay 14 Relay 14
Relay 15 Relay 15
Relay 16 Relay 16
•
Audio Setting
The audio aspects of the keyboard can be configured
Description Default
Volume Changes the sound of the internal buzzer to be more or less noticeable Quiet
PCI mode alarm
When set to Off alarms will not be enunciated whilst in PCI mode
On
•
Revert to Factory Settings
Use this option to reset all configuration on the keyboard to the factory default values. A dialog box will be displayed
asking you to confirm using the
Enter
key, or cancel with the
Clear
key.